UP 8/4 (10m) - submersible electric Pump three-phase 400 V

The prevalent characteristic of the submersible pump UP is the inability to stop responding, even after long periods of inactivity, thanks to innovative and patented technical solutions.

The UP subverts the classic design of the submersible pumps 5”. In fact, compared to pumps of the same type is constructed in an inverse manner, i.e. with the engine in the lower part, the hydraulic cross-section at the top (hence the name UP).
Among his revolutionary strengths are a greater compactness and a system of floating impellers independent that allows you to pump clean water with a maximum sand content can reach 150 g/m3, the only in the world of 5”.

In addition, the UP has reduced consumption, a valve that eliminates the“effect” bell-to facilitate the expulsion of air bubbles which may form inside the pump and the inlet grating raised and not on the bottom to prevent the passage of sand, leaves and other foreign matter that may clog plumbing and reduce the performance.
The UPS is equipped with a system of flushing the forced oil lubrication of the mechanical seals and is available in the versions with float switch or without. Can work both in vertical and horizontal position.

For the high efficiency and reliability is recommended for pumping clean water in domestic, civil, agricultural, irrigation of orchards and gardens, for raising pressure, etc.,