Brio Tank - Electronic pressure regulator
For pumps up to 2 HP. With 1" M connection. With pressure gauge. With autoreset.
Delivery Options
| Carrier | Description | Estimated Delivery | |
|---|---|---|---|
 | Mail Boxes - 2 giorni | This courier delivers within 48 hours from the moment we entrust the products to him. | Wednesday 12 November - Thursday 13 November |
 | Poste Italiane - 2 giorni Italia | This courier delivers within 24/48 hours from the moment we entrust them with the products. | Wednesday 12 November - Thursday 13 November |
 | DHL - 2 giorni Italia | This courier delivers within 24/48 hours from the moment we entrust the products to him. | Wednesday 12 November - Thursday 13 November |
 | Poste Italiane - 3 giorni punto di ritiro | This courier delivers within 24/72 hours from the moment we entrust them with the products. | Tuesday 11 November |
 | Ritiro in negozio | Choose where to collect your order within 24/48 hours. | Tuesday 11 November |
Carrier: Mail Boxes - 2 giorni
Description: This courier delivers within 48 hours from the moment we entrust the products to him.
Estimated delivery:
Wednesday 12 November - Thursday 13 November
Carrier: Poste Italiane - 2 giorni Italia
Description: This courier delivers within 24/48 hours from the moment we entrust them with the products.
Estimated delivery:
Wednesday 12 November - Thursday 13 November
Carrier: DHL - 2 giorni Italia
Description: This courier delivers within 24/48 hours from the moment we entrust the products to him.
Estimated delivery:
Wednesday 12 November - Thursday 13 November
Carrier: Poste Italiane - 3 giorni punto di ritiro
Description: This courier delivers within 24/72 hours from the moment we entrust them with the products.
Estimated delivery:
Tuesday 11 November
Carrier: Ritiro in negozio
Description: Choose where to collect your order within 24/48 hours.
Estimated delivery:
Tuesday 11 November
The Brio Tank automatically controls the start and stop of single-phase electric pumps up to 2HP. It allows you to completely replace the traditional system consisting of a pressure switch and expansion tank.
It starts the electric pump following the decrease in pressure and stops it when the flow of liquid is interrupted at the maximum pressure of the electric pump.
The device incorporates a small 0.4 liter expansion vessel which prevents the continuous start and stop of the electric pump in the event of system leaks or small water requests.
The pressure gauge is integrated which protects against dry running and water hammer.
It can be installed in any position, both vertical and horizontal, respecting the direction of the flow.
- Restart pressure (bar)
- 1 bar
- Line power supply
- single-phase
- Supply voltage (Volts)
- 230
- Engine power supply
- single phase
- Motor voltage
- 230 V
- Dry running protection
- Yes
- Attack size
- 1 "
- Type of attack
- male
Reviews (4) - Review moderation
veloci e affidabilissimi!
Already reported
Il cliente non ha lasciato alcun commento.
Already reported
This is a replacement for an old Brio 2000M. The old Brio continuously stopped and started the pump even if the water flow was as high as 20 L/min. Reset of the flow sensor did not help. Perhaps the sensor is dirty but the sensor cannot be removed for cleaning in the old model. Water should not be particularly dirty because a 50 micron filter is in use. The new 2023 Brio Tank allows very low water flow without stopping the pump. I tested with 3,4 L/min. I had to increase the starting pressure from factory setting by turning the knob 2 total turns clockwise. My highest water tap is about 16 meters above the lake.
Already reported
Velocissimi... Ottimo imballaggio ... Prodotto arrivato come da descrizione.
Already reported
