UP 2/2 (10m) - Three-phase submersible electric pump 400 V 0.50 HP
Flow rate up to 80 l/min (4.8 m³/h). Head up to 33 m. 0.37 Kw (0.50 HP) motor. 10 meters of cable.
The main feature of the UP 2/2 submersible electric pump is the impossibility of blocking even after long periods of inactivity, thanks to innovative patented technical solutions.
The UP 2/2 subverts the classic design standards of 5” submersible pumps. In fact, compared to pumps of the same type, it is built in the opposite way, that is, with the motor in the lower part and the hydraulic section placed in the upper part (hence the name UP).
Among its revolutionary strengths are its greater compactness and a system of independent floating impellers that allows it to pump clean water with a maximum sand content of up to 150 g/m³, the only one in the world of 5”.
Furthermore, the UP features reduced consumption, a valve that eliminates the “bell effect” to facilitate the expulsion of air bubbles that can form inside the pump and the raised suction grid, not placed on the bottom, to prevent the passage of sand, leaves and other foreign bodies that could clog the hydraulics and therefore reduce performance.
The UP is equipped with a forced flushing system for the mechanical seal lubrication oil and is available in versions with or without float. It can operate in both vertical and horizontal positions.
Due to its high performance and reliability, it is recommended for pumping clean water in the domestic, civil and agricultural sectors, for irrigating vegetable gardens and gardens, for boosting pressure, etc.
- Motor connection
- THREE-PHASE
- Power (Kw)
- 0.37
- Power (HP)
- 0.50
- Absorption at 400V (A)
- 1.6
- Delivery port
- 1 "1/4
- Body Pump
- AISI 304 stainless steel
- Impeller
- Noryl
- Number of impellers
- 2
- Motor shaft
- AISI 431 stainless steel
- Check valve
- no
- Degree of protection
- IP 68
- Flow rate min. (l./min.)
- 10
- Max flow (l./min.)
- 80
- Min head (m.)
- 17
- Max head (m.)
- 33
- Cable length (m)
- 10
- Employments
- irrigation
- Liquid temperature max. (° C)
- 40
- Height (cm)
- 39.8
- Outside diameter (cm)
- 15
- Weight kg)
- 13.5
- Guarantee
- 2
|
|
|
|
|
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Bearings
| Pump side motor bearing | 6303 2RS - C3 |
| Opposite side engine bearing | 6203 ZZ - C3E |
Tree holding
| Type of seal | Double mechanical seal in oil chamber |
| Engine side model | STA-17 |
| LM diameter | 17 |
| LM fixed ring | Ceramic |
| LM rotating ring | Graphite |
| LM elastomer | NBR |
| Shrinkage DN1=450 DN2=350 | ST1-16 |
| LP diameter | 16 |
| LP fixed ring | Silicon carbide |
| LP rotating ring | Graphite |
| LP elastomer | NBR |
Materials
| 2.1 - Seal holder cover | Stainless steel EN 1.4301 (AISI 304) |
| 3.0 - Impeller | Reinforced technopolymer |
| 4.0 - Pump shaft | Stainless steel EN 1.4057 (AISI 431) |
| 5.1 - Diffuser | Reinforced technopolymer |
| 5.3 - Diaphragm/Diffuser Cover | Stainless steel EN 1.4301 (AISI 304) |
| 6.2 - Engine sleeve | Stainless steel EN 1.4301 (AISI 304) |
| 7.2 - Pump shirt | Stainless steel EN 1.4301 (AISI 304) |
| 7.3 - Cable cover | Stainless steel EN 1.4301 (AISI 304) |
Compare with Similar Products
 UP 2/2 (10m) - Three-phase submersible electric pump 400 V 0.50 HPThis product Flow rate up to 80 l/min (4.8 m³/h). Head up to 33 m. 0.37 Kw (0.50 HP) motor. 10 meters of cable. |  HR 531 GX - 52 cm flail mowerHR 531GX self-propelled flail mower with 52 cm Orec cut |  BL-IP-2 - 2 zone control unit for cockpitFor installation in the cockpit. Manages 2 irrigation zones. Bluetooth. | |
|---|---|---|---|
| Motor connection | Motor connection THREE-PHASE | Motor connection -- | Motor connection -- |
| Power (Kw) | Power (Kw) 0.37 | Power (Kw) -- | Power (Kw) -- |
| Power (HP) | Power (HP) 0.50 | Power (HP) -- | Power (HP) -- |
| Absorption at 400V (A) | Absorption at 400V (A) 1.6 | Absorption at 400V (A) -- | Absorption at 400V (A) -- |
| Delivery port | Delivery port 1 "1/4 | Delivery port -- | Delivery port -- |
| Body Pump | Body Pump AISI 304 stainless steel | Body Pump -- | Body Pump -- |
| Impeller | Impeller Noryl | Impeller -- | Impeller -- |
| Number of impellers | Number of impellers 2 | Number of impellers -- | Number of impellers -- |
| Motor shaft | Motor shaft AISI 431 stainless steel | Motor shaft -- | Motor shaft -- |
| Check valve | Check valve no | Check valve -- | Check valve -- |
| Degree of protection | Degree of protection IP 68 | Degree of protection -- | Degree of protection -- |
| Flow rate min. (l./min.) | Flow rate min. (l./min.) 10 | Flow rate min. (l./min.) -- | Flow rate min. (l./min.) -- |
| Max flow (l./min.) | Max flow (l./min.) 80 | Max flow (l./min.) -- | Max flow (l./min.) -- |
| Min head (m.) | Min head (m.) 17 | Min head (m.) -- | Min head (m.) -- |
| Max head (m.) | Max head (m.) 33 | Max head (m.) -- | Max head (m.) -- |
| Number of zones | Number of zones -- | Number of zones -- | Number of zones 2 |
| Valves by sector | Valves by sector -- | Valves by sector -- | Valves by sector 1 |
| Number of departures | Number of departures -- | Number of departures -- | Number of departures 8 |
| Number of programs | Number of programs -- | Number of programs -- | Number of programs 1 |
| Cutting width (cm) | Cutting width (cm) -- | Cutting width (cm) 52cm | Cutting width (cm) -- |
| Min cutting height (mm) | Min cutting height (mm) -- | Min cutting height (mm) 20 | Min cutting height (mm) -- |
| Max cutting height (mm) | Max cutting height (mm) -- | Max cutting height (mm) 110 | Max cutting height (mm) -- |
| Cable length (m) | Cable length (m) 10 | Cable length (m) -- | Cable length (m) -- |
| Engine type | Engine type -- | Engine type GX200 OHV | Engine type -- |
| Engine brand | Engine brand -- | Engine brand Honda | Engine brand -- |
| Displacement (cc) | Displacement (cc) -- | Displacement (cc) 200 | Displacement (cc) -- |
| Employments | Employments irrigation | Employments -- | Employments -- |
| Liquid temperature max. (° C) | Liquid temperature max. (° C) 40 | Liquid temperature max. (° C) -- | Liquid temperature max. (° C) -- |
| LCD display | LCD display -- | LCD display -- | LCD display no |
| Wifi | Wifi -- | Wifi -- | Wifi no |
| Non-volatile memory | Non-volatile memory -- | Non-volatile memory -- | Non-volatile memory Yes |
| Remote control | Remote control -- | Remote control -- | Remote control Yes |
| Modular | Modular -- | Modular -- | Modular no |
| Watertight | Watertight -- | Watertight -- | Watertight Yes |
| Assembly | Assembly -- | Assembly -- | Assembly external |
| Compatible with rain sensor | Compatible with rain sensor -- | Compatible with rain sensor -- | Compatible with rain sensor Yes |
| Type of cut | Type of cut -- | Type of cut 32 Y-shaped flagella | Type of cut -- |
| Wheels with bearings | Wheels with bearings -- | Wheels with bearings Yes | Wheels with bearings -- |
| Cutting height adjustment | Cutting height adjustment -- | Cutting height adjustment centralized | Cutting height adjustment -- |
| Supply | Supply -- | Supply -- | Supply battery |
| Battery voltage (Volts) | Battery voltage (Volts) -- | Battery voltage (Volts) -- | Battery voltage (Volts) 9 |
| Number of batteries | Number of batteries -- | Number of batteries -- | Number of batteries 1 |
| Overcurrent protection | Overcurrent protection -- | Overcurrent protection -- | Overcurrent protection no |
| Height (cm) | Height (cm) 39.8 | Height (cm) -- | Height (cm) -- |
| Outside diameter (cm) | Outside diameter (cm) 15 | Outside diameter (cm) -- | Outside diameter (cm) -- |
| Weight kg) | Weight kg) 13.5 | Weight kg) -- | Weight kg) -- |
| Guarantee | Guarantee 2 | Guarantee -- | Guarantee 2 |
| Solenoid operation | Solenoid operation -- | Solenoid operation -- | Solenoid operation bistable |
| Simultaneous programs | Simultaneous programs -- | Simultaneous programs -- | Simultaneous programs no |
| Odd and even day programming | Odd and even day programming -- | Odd and even day programming -- | Odd and even day programming Yes |
| Weekly programming | Weekly programming -- | Weekly programming -- | Weekly programming Yes |
| Self-propelled | Self-propelled -- | Self-propelled Push | Self-propelled -- |
